Please complete the mixer design request form below as far as possible. It is not necessary to complete all fields for standard applications. Sections 1 to 4 must however be completed in full to allow a design to be concluded.     Section 1 - Contact Information       Name Title Company Address Telephone FAX E-mail     Section 2 - Mixer General Information       Mixer Description Number of Units     Section 3 - Product Data       Product Description Fluid Density (kg/m3) Fluid Viscosity (cPoise or mPa.s)     Section 4 - Vessel Dimensions       Inner Diameter or Length X Width (in metres) Shell Height (in metres) Bottom Shape (Flat, ASME Dish, 15 ° cone etc.) Top Shape (Flat, ASME Dish, 15 ° cone etc.) Working Volume (m3) Maximum Volume (m3) Minimum Volume (m3)     Section 5 - Mixer Position       Top Entry Side Entry Bottom Entry     Section 6 - Vessel Conditions       Temperature (° Celcius) Pressure (gauge, in kPa)     Section 7 - Process Data and Comments     Include additional information such as particle size distribution and density for solids suspension or specifics of processes such as heat transfer, gas dispersion, solvent extraction or multi-component blending information.       Section 8 - Mechanical Data and Comments     This section should contain any specific requirements for the equipment such as (but not limited to) preffered make of electrical motors, mechanical seals as well as special flange mounting geometry required.